How to observe radio emission from the solar corona


Joachim Köppen Strasbourg 2013


The ground station can also be used to observe radio emission from the Sun. in the signal. While at 432 MHz (indicated by the right hand magenta line) the station is sensitive enough to pick up the signal, the solar flux at 144 MHz is too low for our instrument - the sensitivity corresponds roughly to an antenna with effective diameter of 1 m:

However, this is not the only constraint: The electronic noise at the Illkirch site with all the electronics in the building itself as well as all the electronics present on this campus has become so high that on 20 MHz (RadioJove) we can no longer observe any radio bursts from the active ("disturbed") sun, on 144 MHz the sun is undetectable, and on 432 MHz it is just detectable. Above about 1 GHz the Sun is easily observable (with the ESA-Haystack and ESA-Dresden radio telescopes). Solar radio fluxes measured every day by a international network of observatories can be downloaded from Solar Indices Bulletin from NOAA. Note that 1 SFU (solar flux unit) corresponds to 10000 Jy:

What do we see from the Sun, depends on the frequency of observation: Because the solar plasma becomes more transparent at higher frequencies, we thus can see into deeper layers:

Thus, observations at various radio frequencies reveal the temperature profile in the outer atmosphere of the Sun:

We can use the ground station to observe the Sun, simply by pointing manually the antenna to the Sun (the azimuth and elevation values can be obtained from the software that controls the ESA-Dresden telescope). We measure and record the signal strength in the same way as we do it with satellites ... but when the trace on the software reached the right hand edge of the screen after several minutes, we turn the antenna to the left for about 90 but we stay at the same elevation. We now measure the empty sky, again for several minutes. Then we move the antenna again to the Sun (but at its current position) ... and so on: a pretty boring job! But this is necessary to measure the Sun as well as the sky without the Sun. At the position of the empty sky we measure the noise background from the receiver, which we need to subtract from the observations. An example of such an observation sequence is shown below

This plot shows that the solar signal is only 1 dB above the background level ... this is less than one should expect from the technical specifications of the station equipment: one should expect about 5 to 6 dB. The reason is very simple: the background is not just the noise from the receiver, but it is the electronic noise pervading the campus!

Since the antenna pattern is rather wide (HPBW=28), it is not possible to calibrate properly the system by pointing the antenna to a sufficiently wide building or woods which would constitute a calibration source of known temperature ...

However, if one works out the signal level from the solar flux measured by professional stations, the observed level is fully consistent with a coronal temperature of about 2000000 K!


| Top of the Page | Back to the MainPage | to my HomePage |


last update: July 2013 J.Köppen